Editing Apparel

Jump to navigation Jump to search

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.

Latest revision Your text
Line 84: Line 84:
 
Thus each ''effective'' point of armor gives 0.5% to harmlessly deflect damage, and another 0.5% chance to mitigate it, instead receiving half the damage as blunt damage. Each effective armor point below 100% results in a net 0.75% reduction in damage, while each point above results in a 0.25% reduction. This means that at 200% effective armor rating, colonists will be completely immune to damage; this currently works only on heat damage which lacks armor penetration, and can be seen on [[mechanoid]]s. [[Cataphract armor]] at Legendary quality comes at a close second, reaching 200% sharp rating, but all sharp attacks have armor penetration meaning that even a pawn hit too many times will fall.
 
Thus each ''effective'' point of armor gives 0.5% to harmlessly deflect damage, and another 0.5% chance to mitigate it, instead receiving half the damage as blunt damage. Each effective armor point below 100% results in a net 0.75% reduction in damage, while each point above results in a 0.25% reduction. This means that at 200% effective armor rating, colonists will be completely immune to damage; this currently works only on heat damage which lacks armor penetration, and can be seen on [[mechanoid]]s. [[Cataphract armor]] at Legendary quality comes at a close second, reaching 200% sharp rating, but all sharp attacks have armor penetration meaning that even a pawn hit too many times will fall.
  
Armor is calculated per item of apparel, from the item occupying the outermost layer in. Armor mitigation does stack multiplicatively, e.g. two pieces of armor layered on top of each other can each mitigate the damage by 50%, reducing it to 25% of the base damage. Each layer also has an independent chance to entirely negate the damage, using the above calculation steps.
+
Armor is calculated per layer, from the outside in. Armor mitigation does stack multiplicatively, e.g. 2 successive layers of armor can each mitigate the damage by 50%, reducing it to 25% of the base damage. Each layer also has an independent chance to entirely deflect the damage, using the above calculation steps.
  
 
Armor Penetration is applied identically to each layer.  This means that, while multiple layers of armor each have more chances to mitigate the damage, layering apparel with low armor values may do little or nothing against projectiles with high armor penetration, while a single layer of high armor value may be able to mitigate it.
 
Armor Penetration is applied identically to each layer.  This means that, while multiple layers of armor each have more chances to mitigate the damage, layering apparel with low armor values may do little or nothing against projectiles with high armor penetration, while a single layer of high armor value may be able to mitigate it.

Please note that all contributions to RimWorld Wiki are considered to be released under the CC BY-SA 3.0 (see RimWorld Wiki:Copyrights for details). If you do not want your writing to be edited mercilessly and redistributed at will, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource. Do not submit copyrighted work without permission!

Cancel Editing help (opens in new window)